Correct method: If the material is too wet, there may be Advantages of Ultrafine Mill poor discharge of the material 20 minutes before starting. At this time, pay attention to observation before starting. If the counterweight rod does not move for a long time, you can use a rubber hammer to lightly tap the lower part of the large cyclone collector. It is strictly prohibited to strike with iron products such as a hammer, especially the control valve.
Large cyclone collector: When the large cyclone collector is blocked, it is strongly beaten with iron parts such as a hammer. Harmfulness: the barrel is deformed and the yield is reduced. The correct method: first determine whether the silo is full, the powder cannot be discharged, or the material is too wet. Slight blockage can be achieved with a rubber hammer. In severe cases, the cover of the control valve should be opened, the material should be passed through a thin steel bar, and then beaten with a rubber hammer.
Residual gas small valve: slightly open under normal conditions, to ensure that the main machine inlet has a certain suction phenomenon. If the opening is too large, ① automatic suction will occur, and the automatic control of the host will fail to cause blockage. ② A large amount of dust-laden air enters the dust collector, causing the dust collector to be overloaded and the cloth bag is easy to wear. ③ The amount of air entering the host is reduced accordingly, and the output is reduced. ④ Large particles are easy to appear in powder products. 9. Each oiling hole such as the grinding roller device in the main engine, the screw plug is not screwed back or tightened after oiling, resulting in powder in the bearing and burning the bearing. 10, simple dust collector: insufficient filtering area, resulting in poor exhaust gas discharge, dust spray at the inlet of the host. 12. It is strictly forbidden to hit the pipes with iron parts such as hammers and iron bars.
